4
E109793#1
INSTRUCTIONS
9. Screw the connector block (12) as shown in Abb. (k) to the
underside of the chassis with the machine screws (7) and
nuts (11) tighten.
Abb. k
Underne-
ath view
11. Place a reducer (13) in the centre of each wheel (5) Place
the wheels on a an axles ( Abb. m)
Abb. m
13. Check the drive direction before fastening the solar cell.
If the drive rotates in a forward direction, the solar cell
(6) can be to the holder using a hot glue gun
Abb. o
Abb. n
12. Remove 10mm of the insulation from the end of the red cable on
the solar motor.
Thread it through the hole and connect it to the screw on the solar
cell. The red cable is connected to the minus pole and the black
cable to plus pole. (siehe Abb. n)
10.Insert the wire rod bumper in the connector block and screw
in place (9) (siehe Abb. l)
Abb. l
5
13
