Opitec 102.056, Руководство по сборке

Страница: 7 / 25

7
E102056#1
7.2 Tailplane and Fin
7.2.1 Cut out te pattern for the tailplane (7) (Plan 8). Apply spots of glue to the rear of the pattern and lay it out on
the foam sheet 3 x 114 x 410 (See page 4). Firstly cut out the 3mm slot in the Tailplane using a steel ruler
and sharp modelling knife (7) and then the remaining contours.
7.2.2 Cut out the Fin (8) and remember the lower fixing tab.
Note:
The directional (long) flap is cut after the plane has been flown
7.2.3 Sand the curves of the Fin and Tailplane to shape with a block and glasspaper.
Note:
The underneath of the Fin (8) must not be sanded!
7.2.4 Ensure the Fin fits in the slot in the Tailplane.
7.2.5 Glue the Fin into the slot in the Tailplane and leave to dry
Note:
The Fin must be at right angles to the Tailplane
7.2.6 Mount and glue the Fin and Taiplane on the Fuselage (3) and leave to dry!
Note:
Make sure that it is mounted squarely with the Fuselage otherwise the flight pattern will be
affected!
Do NOT sand the
underneath of the
Fin (8)
This long cut for the
flap is cut after the first
flight
7
8