Opengear MUX-6258-A-261, Руководство пользователя

Страница: 20 / 60

2–4 • Installation MUX-6258-A Series User Manual (Iss. 04)
5.
Align the top hole of the Rear Module with the screw on the top-edge of the frame back
plane.
6.
Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back
plane of the frame. Do not over tighten.
7.
Ensure proper frame cooling and ventilation by having all rear frame slots covered with
Rear Modules or Blank Plates.
Installing the Card
The MUX-6258-A series uses a single mode, LC/UPC connector to interface with the Rear
Modules. The procedure in this section is applicable to all versions of the MUX-6258-A series
cards.
To install the card in a DFR-8321 series frame
1.
Locate the Rear Module you installed in the procedure “ Installing a Rear Module ” on
page 2-3.
2.
Ensure the Rear Module is the 8320AR-048A Full Rear Module.
3.
Remove the dust cap from the connector on the card end.
• Refer to Figure 2.1 and Figure 2.2 for dust cap locations.
• Refer to the section “ Important Laser Safety Measures and Notices ” at the
beginning of this manual for safety information when handling fiber optic
components.
4.
Ensure that the exposed surface of the ceramic ferrule of the connector is clean. Refer to
the section “
Working with Fiber Optic Connectors ” on page 2-2.
5.
Hold the card by the edges and carefully align the card-edges with the slots in the frame.
6.
Fully insert the card into the frame until the rear connection plus is properly seated in the
Rear Module. You will feel a click when the card mates onto the rear module.
7.
Affix the supplied Rear Module Label to the BNC area of the Rear Module.
8.
Remove the dust cap from the
Fiber 1
port (the topmost fiber optic port) on the Rear
Module that faces the exterior of the frame.
9. Ensure the ceramic ferrule of the Fiber 1 port connector is clean.
10. Cable your rear module as outlined in the section “ Cabling ” on page 2-5.