Opengear MUX-6258-A-261, Руководство пользователя

Страница: 26 / 60

3–2 • User Controls MUX-6258-A Series User Manual (Iss. 04)
Card Overview
This section provides a general overview of the card components. For information on the LEDs
available on the card-edge, refer to the section “
Control and Monitoring Features ” on page 3-3.
Figure 3.1 MUX-6258-A — Card-edge Components
1. Function Select Switch
Use this switch to select general operation functions and menu items. This switch works in
conjunction with the Mode Select Switch.
2. Mode Select Switch
Use this switch to enable, disable, and select specific configurations within the operational
function modes menu (selected first with the Function Select Switch).
3. Four Character Display
This display is located on the card-edge and reports the menu and options selected using the
Function Select Switch and the Mode Select Switch.
4. Bootload Button
This button for factory service in the unlikely event of a complete card failure. Do not press this
button unless instructed to do so by Ross Technical Support personnel.
5. Fiber Optic Connector
The cards use a blind mate, single mode, LC/UPC connector to interface with the Full Rear
Module (8320AR-048A). The rear module is passive, which allows for the card to be replaced
without the need to remove any connected BNC or fiber optic cables.
The fiber optic connector for the card includes a dust cap. The dust cap must stay on at all times
when the card is not installed in a frame. Ensure to keep the fibers end face clean and use the caps
to protect the fiber from scratches and collecting dust.
For More Information on...
• using the switches, refer to the section “ Navigating the Card-edge Menus ” on page 5-2.
• the LEDs located on the card-edge, refer to the section “ Status and Selection LEDs ” on
page 3-3.
• safety information when handling fiber optic components, refer to the section
“ Important Laser Safety Measures and Notices ” at the beginning of this manual.
• fiber optic connectors, refer to the section “ Working with Fiber Optic Connectors ” on
page 2-2.
1) Function Select Switch 3) Four Character Display 5) Fiber Optic Connector
2) Mode Select Switch 4) Bootload Button