Opengear 9913DA-AES110-RG, Руководство пользователя

Страница: 24 / 41

3-2
• • • •
User Controls 9913DA-AES110-RG
User Manual
Card Overview
This section provides a general overview of the 9913DA-AES110-RG DIP Switches. Refer to
Figure 3.1 for DIP Switch location
Figure 3.1 9913DA-AES110-RG — Components
SW1 – Remote Control
Use
SW1
to disable remote control of the 9913DA-AES110-RG from DashBoard.
Set
SW1
as follows:
• ON — Select this setting to disable remote control from DashBoard. The parameters and
settings cannot be changed via DashBoard and must be changed using the card-edge
controls. You can still monitor the status of the card using DashBoard.
• OFF — Select this setting to control the 9913DA-AES110-RG exclusively from
DashBoard. The card-edge controls are ignored. This is the default setting.
SW2 — DIP Switch Control
Use SW2 to determine whether DIP Switch settings are applied or ignored.
Set
SW2
as follows:
• ON — DIP Switch status is reported in DashBoard, and DIP Switch settings are applied.
Any parameter adjustments made in DashBoard are ignored.
• OFF — DIP Switch status is reported in DashBoard, however DIP Switch settings are
ignored. Parameter adjustments made in DashBoard are applied. This is the default
setting.
SW3, SW4 — Output Mode Selection
SW3
and
SW4
are used in conjunction to set the output mode of the 9913DA-AES110-RG. Refer
to the section “ Setting the Output Mode ” for details.
SW5
This DIP Switch is not implemented.
SW6 – SW10 — Gain Control
These switches are used in conjunction to apply a specific Gain value (dB). Refer to the section
“
Specifying the Gain ” for details.