OpenEye OE-ENVR16, Руководство пользователя

Страница: 18 / 74

33086AA 19
Connecting the Monitor
There are two available monitor outputs on E-Series NVR recorders.

HDMI output for HDMI monitor

VGA output for VGA monitor
Connecting to a Network
Use the RJ45 jack on the rear of the recorder when connecting to a network or PoE switch.
Connecting Audio
To listen to live or recorded audio connect the Audio Out Port to an amplified speaker system.
The audio output is a line level source which requires an amplified speaker system.
Connecting to a Sensor Input
To make connections on the Alarm Connector Strip: Loosen the tension screw and insert the
wire into the hole. Tighten the tension screw to secure the wire.
To disconnect the wire: Loosen the tension screw and pull the wire out of the hole.
Sensor In
Use external devices to send a signal to the recorder when an event occurs. Mechanical or
electrical switches can be wired to the Sensor In and Ground (G) connectors.
All connectors marked G are common. Connect the ground side of the sensor input
and/or alarm output to the G connector.
Connecting to a Relay Output
To make connections on the Alarm Connector Strip: Loosen the tension screw and insert the
wire into the hole. Tighten the tension screw to secure the wire.
To disconnect the wire: Loosen the tension screw and pull the wire out of the hole.
Alarm Out
The recorder can activate external devices such as buzzers or lights. Connect the external
device to the Alarm Out and Ground (G) connectors. See Sensor Setup in the manual for
more details.