OP
S.r.l.
25131 BRESCIA - Via Serpente, 97 - Tel. 030/3580401 - Fax 030/3580838
___________________________________________________________________________
40
ROUTINE MAINTENANCE
•
It is imperative that all the operations on the machine be executed by qualified and
authorized personnel acquainted with its operating modes.
•
Never execute any cleaning, lubrication or maintenance operation while the machine is
on.
•
Before any maintenance operation press the STOP button, disconnect the electric plug,
then proceed with the maintenance operation.
•
Grease moving parts once every 6 months, type of grease recommended KLUBER
STABURAGS NBU 30 or equivalent (viscosity of standard oil DIN 51561 mm2/s approx.
at 40°C 500 – to 100°C 31).
•
Check the oil level regularly and top up if necessary through the filler cap placed on top
of the machine (use only oil with characteristics indicated at pag. 38).
•
Change the oil in the central unit, clean or substitute the filters every 3000 working
hours.
•
Before operating the press always check the efficiency of the safety devices.
•
Preventively check the state of the connections, the integrity of the tubes to avoid oil
leaks or other anomalies, by executing some idle manoeuvres
•
Daily verify the wear and tear and the readability of the warning signs.
•
Promptly eliminate dust and water deposits, or dirt that could alter the proper
functioning and the life of the equipment.
•
In case of pump malfunction (also detectable by the noise) disassemble it and
substitute it with a new one. It is recommended to entrust the manufacturer with the
repair job.
•
Frequently check the efficiency of the emergency stop devices and limit switches.
•
Replace the fitted hoses after about six years
•
Regularly check the proper tightening of the guide screws and nuts.
•
Regularly check the proper tightening of the screws.
E
N
G
L
I
S
H
