OP S.r.l.
Via Serpente 97 25131 Brescia Italia Tel. +39.030.3580401 Fax. +39.030.3580838
________________________________________________________________________________________________
26
SELECTING THE PRESSING DIES
Note: the sets of dies listed in the following table are for TUBOMATIC H46 and H46/E
presses.
Dies with customized rated diameters may be supplied upon request.
DATA ON AVAILABLE DIES
Code
Minimum (rated)
pressure Ø (mm)
Maximum
recommended crimping
force Ø (mm)
Dies lengths
(mm)
TUBH46M10
10
12
55
TUBH46M12
12
14
55
TUBH46M14
14
16
55
TUBH46M16
16
19
55
TUBH46M19
19
23
55
TUBH46M23
23
27
55
TUBH46M27
27
31
65
TUBH46M31
31
39
65
Dies holders
39
46
64
REPLACING THE DIES
After choosing the desired set of dies according to the diameter to be pressed, carefully
follow these instructions:
1.
Retract the piston by turning the oil check valve counterclockwise to open the dies
holder and have enough room to replace or fit the dies.
2.
Insert the die (item 1 in Figure 2) into the die holder (item 2 in Figure 2) so that the
reference pin (item 3 in Figure 2) is inserted into the hole on the die holder and locks
onto the ball crimping device (item 4 in Figure 2). Repeat the operation for the
remaining dies.
3.
To replace the die, apply pressure to the die in order to release the reference pin from
the ball crimping device.
Note:
as time passes, the pressure applied by the crimping device (item 4 in Figure 2)
inside the die holder on the die reference pin (item 3 in Figure 2) could weaken. In
this case it is necessary to adjust or replace it by means of the locking stud bolt
(item 5 in Figure 2).
E
N
G
L
I
S
H
