1
The A
LUMAX
394 S
TIK
S
TALL
Shower Enclo-
sure is completely reversible and may be installed
pivot-left or pivot-right. For maximum water-
proofing, the pivot jamb should always be opposite
the shower head. Using the illustration, deter-
mine the correct position for the door in your
particular S
TICK
S
TALL
installation. This instruc-
tion sheet depicts a pivot-right installation.
NOTE: Fixed glass panel sizes should be deter-
mined by formulas shown on A
LUMAX
detail sheets.
2
Assemble the three curb sections [
A
] (with
weep slots) by sliding two 135° anchor plates [
B
]
into the mitered ends and forcing the sections
together. The weep slots in the curbs must be to
the inside. Using the slotted holes in the anchor
plates as a guide, drill matching 1/8" holes into the
curbs. Secure the anchor plates to the curb assem-
bly with eight #8 x 1/4" truss head screws [
C
]. As
you tighten the screws, be sure the miters are
forced tightly together. To increase the rigidity of
the mitered joint, drill and install two more screws
through the round holes in the bracket.
Assemble the three header sections [
D
] in the
same manner and set the header assembly aside.
3
Using a 1/8” drill bit, drill the interior face of the
curb assembly [A] on both ends as shown.
Reposition the curb assembly on the shower sill
and mark its position with a pencil line along the
interior and exterior base.
NOTE: The curb track is already cut to size.
(The header track will need trimming in step #7)
THIS MA Y ARRIVE
PRE-ASSEMBLED
Page 3 of 8
CAUTION:
For safety reasons, the door pane must
always open outward.
1/8
”
DIA.
(The header track will need trimming in step #7)
