DX26/DX32 OPERATOR MANUAL
14
Rev 4 –11/4/2021
Machine Operation & Duration
WARNING:
Fire or explosion hazard. Please do not pick up flammable materials or
reactive metals.
1.
Switch the key of the main power supply to the position of (
Ⅰ
).
2.
Pull down the squeegee lifting rod to lower the squeegee to the ground.
3.
Turn on the brush head lifting switch to lower the brush head to the ground.
4.
Push down the accelerator trigger, the machine starts to work.
5.
Recommend each cleaning path overlaps by 2”.
6.
Let the machine advance constantly to avoid ground damage.
7.
If there is drag mark on the ground after the squeegee absorbs water, check the
squeegee blade for debris, and clean accordingly.
8.
Do not operate the machine on the slope with a slope over 5% (3°).
9.
If there is too much foam entering the wastewater tank, check the
foamer/detergent concentration and adjust accordingly.
Note
:
Do not let the foam enter the filter screen so as to avoid damage to vacuum
motor. The foam will make the switch of the filter screen invalid.
10.
Replace or rotate the pad as required.
11.
Observe the power consumption of the battery power meter
12.
For traditional scrubbing operations, the consumption is typically 10 liters of fluid
for each 10 minutes of operation, roughly one liter per minute.
13.
When the solution in the clean water tank is used up, empty the waste water tank
by accessing the waste water drain hose of the back of the machine, then re-pour
the cleaning solution.
14.
To stop machine operation, stop and place the machine on the level ground, release
the accelerator paddle, position Key Switch to off and remove the key.
After cleaning, carry out daily maintenance procedure.
