6.5 - Appendix F: Safety Information
Do not open or modify the device. The device uses components that comply with FCC and CE
regulations. Modification of the device may void these certifications.
Ne pas ouvrir ni modifier l'appareil. L'appareil utilise des composants conformes aux réglementations
FCC et CE. La modification de l'appareil peut annuler ces certifications.
6.5.1 - Safe Use and Installation Instructions
1. Install the device securely. Be careful handling the device to prevent injury and do not drop.
2. To protect against excessive RF exposure, maintain at least 20cm from any user and the RF
antennas. Only use provided dual band antennas of 2dBi/2dBi gain
.
3. Wall or ceiling mounting the device requires use of a mounting plate or bracket. The plate or
bracket must be of metal construction and have a minimum thickness of 1mm.
4. Use M3x0.5mm Flat Head screws to attach mounting plate or mounting brackets to threaded
holes on bottom or rear of chassis. Screws should be a minimum length of 4mm. Add 1mm
of screw length for every mm of additional thickness of plate or bracket beyond 1.5mm.
5. Ambient operating temperature must be between-40 °C to 70 °C with a non-condensing
relative humidity of 10-90%.
6. The device can be stored at temperatures between -40 °C to 85 °C.
7. Keep the device away from liquids and flammable materials.
8. Do not clean the device with liquids. The chassis can be cleaned with a cloth.
9. Allow at least 2 inches of space around all sides of the device for proper cooling. If the device
is mounted to a vertical surface then recommended device orientation is so that heatsink fins
allow air to rise unobstructed. Alternative orientations may result in reduced operational
temperature range.
10. This device is intended for indoor operation only.
11. Use UL Listed external power supply with rated output 9-48Vdc
12. Install the device only with shielded network cables.
13. Only use SAE approved cables for automotive installation.
14. The installer should be experienced in aftermarket installation and familiar with general
practices for installing electronics devices in vehicles.
15. The device should not be installed in the driver’s area of a vehicle.
16. The device should be mounted in accordance with accepted aftermarket practices and
materials for vehicle installation.
17. Only use UL Listed connectors for connection to automotive fuse panels.
18. Radio device is not intended for emergency service use.
19. Service and repair of the device must be done by qualified service personnel. This includes,
but is not limited to, replacement of the CMOS battery. Replacement CMOS battery must be
of the same type as the original.
20. Proper disposal of CMOS batteries must comply with local governance.
WARNING:
There is danger of explosion if the CMOS battery is replaced incorrectly.
Disposal of battery into fire or a hot oven, or mechanically crushing or cutting of a battery
can result in an explosion.
35
