Online UPS Specialist OPP Series, Руководство по эксплуатации

Страница: 27 / 52

- 27 - Revision 1.0
Installation and Set-up
Use the following method to install REPO
switch;
•
Verify that the UPS is off and unplugged
•
Remove the REPO connector from the rear of the UPS
•
Connect isolated, normally closed, dry contacts (rated at
60Vdc maximum, 30Vac RMS maximum and 20mA
maximum), between pins 1 and 2 as shown below;
•
Use stranded, non-shielded wiring – size 18 – 22 AWG.
•
Replace the REPO connector into rear of UPS
•
Verify that the externally connected REPO switch is off, to
enable power to the UPS output receptacles.
•
Plug in the UPS and start the UPS by pressing the input
breaker to “ON”
•
Turn on the external REPO switch to test REPO function
•
Turn off REPO switch and restart UPS for normal operation.