Onkyo HT-R980, Инструкция по эксплуатации

Страница: 24 / 148

24
En
Using Audyssey 2EQ
®
Using Audyssey 2EQ to create a listening environment in
your home theater that all listeners will enjoy,
Audyssey 2EQ takes measurements at up to 3 positions
within the listening area. Position the microphone at ear
height of a seated listener with the microphone tip pointed
directly at the ceiling using a tripod. Do not hold the
microphone in your hand during measurements as this will
produce inaccurate results.
a
First measurement position
Also referred to as the Main Listening Position this
refers to the most central position where one would
normally sit within the listening environment. 2EQ
uses the measurements from this position to calculate
speaker distance, level, polarity, and the optimum
crossover value for the subwoofer.
b
Second measurement position
The right side of the listening area.
c
Third measurement position
The left side of the listening area.
The distances from position a to b and a to c must be
at least 1 meter.
Note
• Make the room as quiet as possible. Background noise and Radio
Frequency Interference (RFI) can disrupt the room measure-
ments. Close windows, televisions, radios, air conditioners, flu-
orescent lights, home appliances, light dimmers, or other
devices. Turn off the cell phone (even if it is not in use) or place
it away from all audio electronics.
• The microphone picks up test tones which played through each
speaker as Audyssey 2EQ Room Correction and Speaker Setup
run.
• Audyssey 2EQ Room Correction and Speaker Setup cannot be
performed while a pair of headphones is connected.
TV
c ab
: Listening area
a
to
c
: Listening position
1
Turn on the AV receiver and the connected TV.
On the TV, select the input to which the AV
receiver is connected.
2
On the SKW-980 Subwoofer, set the OUTPUT
LEVEL control to “THX POSITION”.
3
Set the speaker setup microphone at the Main
Listening Position
a
, and connect it to the
SETUP MIC jack.
The speaker setting menu appears.
Note
• The on-screen setup menus appear only on a TV that is
connected to the
HDMI OUT
. If your TV is connected
to the MONITOR OUT V or the COMPONENT
VIDEO OUT
, use the AV receiver’s display when
changing settings.
4
When you’ve finished making the settings, press
ENTER .
5
If you use a powered subwoofer, adjust the sub-
woofer volume level to 75 dB.
Test tones are played through the subwoofer. Use
the volume control on the subwoofer.
Note
• If you set the subwoofer’s volume control to its maxi-
mum and the displayed level is lower than 75 dB, leave
the subwoofer’s volume control at its maximum and
press
ENTER to proceed to the next step.
6
Press ENTER .
Audyssey 2EQ Room Correction and Speaker
Setup starts.
Test tones are played through each speaker as
Audyssey 2EQ Room Correction and Speaker
Setup runs. This process takes a few minutes.
Please
refrain from talking during measurements
and do not stand between speakers and the micro-
phone.
Do not disconnect the speaker setup microphone
during Audyssey 2EQ Room Correction and
Speaker Setup, unless you want to cancel the
setup.
7
Place the setup microphone at the next position,
and then press
ENTER
.
Audyssey 2EQ performs more measurements.
This takes a few minutes.
Speaker setup microphone
SETUP MIC jack
2EQ: Auto Setup
Speaker Terminal Assign
Front
High/Zone2
SurrBack/Front High
Front High
Surr Back