27
Interlace
For ordinary TV: turn on the interlace mode.
z
When your TV is not compatible with progressive
scan, never select “P-scan”. No picture will be shown
on the monitor.
In case you select “PROGRESSIVE” by mistake,
disconnect the connection of the unit and the TV,
and then connect in again. And change the setting
to “INTERLACE” in the Video Setup menu.
Quality
You can adjust some parameters of video picture.
1
Highlight “Quality” and press the
X
button.
2
Use the
W
/
X
buttons to select the parameter.
Sharpness
This adjusts the sharpness of the picture shown on
the monitor.
Select High, Medium or Low using the Cursor
buttons, and press the Enter button.
Brightness
This adjusts the brightness of the picture.
Use the left and right buttons to change the value,
and press the Enter button.
Contrast
This adjusts the picture contrast.
Use the left and right buttons to change the value,
and press the Enter button.
Gamma
This adjusts the gamma value of the picture.
Select High, Medium, Low or None using the Cur-
sor buttons, and press the Enter button.
Hue
This adjusts the green/red balance of the picture
(only for progressive-scan and S-Video output).
Use the left and right buttons to change the value,
and press the Enter button.
Saturation
This adjusts the saturation level.
Use the left and right buttons to change the value,
and press the Enter button.
Luma Delay
This adjusts the luma delay.
Select 0T or 1T using the Cursor buttons, and press
the Enter button.
3
Press the left button (
W
) to return to the Video Setup
Page.
HDMI Setup
Auto
Select this to have the signal output when your TV
or monitor is connected to the HDMI out terminal.
Off
Select this when you do not use the HDMI out
terminal.
No signal is output from the HDMI out terminal.
Preference Setup
TV Type
Pal
Select this when the unit is connected to a PAL TV.
Auto
Select this when the unit is connected to a Multi TV.
Ntsc
Select this when the unit is connected to an NTSC
TV.
Audio, Subtitle, Disc Menu
You can select a preferred language for audio, subtitle
and disc menu.
z
When you select a preferred language that is not
recorded on the DVD, one of the recorded
languages is automatically selected.
z
You can override the Audio setting in the Setup
menu by pressing the AUDIO button on the remote
control unit while a DVD disc is playing.
z
You can override the Subtitle setting in the Setup
menu by pressing the SUBTITLE button on the
remote control while a DVD disc is playing.
z
Select OffF to turn subtitles off. Note that subtitles
on some discs cannot be removed even when you
select Off.
Parental
Playback of some DVD discs can be limited depending
on the age of the users. The parental control system
allows the playback limitation level to be set by the
parent.
Notes:
z
The lower the level, the stricter the limitation.
z
If the rating of the loaded DVD disc is higher than
the level you set, the system will require a password.
Enter your password and press the Enter button to
start playback.
