www
.onfilter
.com
www
.onfilter
.com
1
CleanSweep
®
AC EMI Filters
for Soldering
APxxxxLG Series
User’s Guide
4
Specification
Rated Voltage, RMS
110...250V AC (refer to filter’s label)
Rated Current, RMS
3A
Power Line Frequency
50/60 Hz
Transient Signal Attenuation (Typical) 0.1/100 Ohms Interface
Differential Mode
24dB
Common Mode
20dB
Continuous Signal Attenuation (Typical) 0.1/100 Ohms Interface
Low Frequencies
50dB
High Frequencies
25dB
Power Indication
LED
Dimensions (WxDxH)
3.12”x1.85”x5.0” ( 80x47x127mm)
Ambient Temperature
+5
0
.. . 40
0
C
Climatic Category
+05/040/00
Filter Care
Normally, filter requires no maintenance and no calibration. It is recommended, though, to
periodically inspect filter for overheating and to clean its surface with dry cloth.
During its normal operation filter may have elevated temperature
which would feel “warm” to the touch, but not what is considered
“hot.” If the filter does feel “hot” to the touch (more than 70
0
C or
158
0
F), turn your equipment off, disconnect filter from the circuit
and discontinue using it. For warranty or other repairs contact
factory or its authorized distributors. Full text of warranty can be
found in the Library section at www.onfilter.com
Patent Pending. All specifications are subject to change without notice. Made in U.S.A.
Please r
ec
yc
le
. Printed in USA.
© 2014 OnFIL
TER,
Inc
.
All rights r
eser
ved.
PUB03203
Typical Performance of CleanSweep
®
Soldering Filter
Current from the iron’s tip without CleanSweep
®
filter
Current from the iron’s tip with CleanSweep
®
filter
OnFILTER, Inc.
730 Mission St. Ste.102
Santa Cruz, CA 95060 USA
Tel. +1.831.824.4052
FAX +1.206.350.7458
www.onfilter.com
[email protected]
4010859
AC outlet may vary depending
on the specific model
Included:
APxxxxLG Filter
1 ea.
Power Cord
1 ea.
