ONECELL25 - Installation Manual
22
8
Getting Started
When the router is delivered with the default OneAccess factory settings, the router
is configured as follows:
•
FASTETHERNET 0/0
port is configured with the IP address 192.168.1.1
(netmask: 255.255.255.0)
•
DHCP
server is enabled
•
HTTP server for fast web-based configuration is enabled
8.1
Connect your PC
Your PC should be configured to acquire its IP address via DHCP protocol;
alternatively, you can assign a static IP address to your PC LAN interface in the
network range 192.168.1.2 – 192.168.1.254.
Connect your PC with a LAN cable (straight or crossed; the ONECell25 adapts to
both wiring).
The Ethernet interfaces of the ONECell25 only support the 100 Mbps full-
duplex operations in auto-sense mode. If connected to devices in 10 mbps
or half-duplex, the ONECell25 interface will not be connected. The problem
can appear mostly with devices forced in such mode or with old Ethernet
hub.
8.2
Starting the Web Configurator
Open a web browser and use the following URL:
http://192.168.1.1/
The web configurator developed by OneAccess uses intensively javascript.
It has been tested with Internet Explorer version 6 and 7 as well as Firefox 2.
Using the web configurator with other web browsers may not work and are
not supported by OneAccess.
You will be directed to a login page. The default login is
webadmin
and the
password is
admin
.
It is recommended to use the EDGE connection wizard to setup the EDGE
connection.
Please consult the web user manual for more details.
