OneAccess ONE100D/M, Руководство по установке

Страница: 37 / 67

ONE100D/M Chapter 4
Installation Guide Interface description
37
4.1 The different connectors on the back panel of the ONE100D/M
Depending on the version of the ONE100D/M, some of these connectors may or may not be present.
Refer to
3.5 - Rear view of the ONE100D/M on page 24 for an overview of the different versions that
exist.
The following table gives an overview of the possible connectors located at the back of the ONE100D/
M and explains their function:
Label Function
SHDSL This RJ45 connector is the SHDSL line connector.
Connect one side of an SHDSL line cable (not included) to the LINE connector of
the ONE100D/M and the other side to an SHDSL outlet.
For optimum performance, the used line pairs have to be properly twisted
pairs.
Refer to 4.3 - SHDSL line specifications on page 42 for the pin lay-out of this con-
nector.
CONSOLE This RJ45 connector is a V.24 DTE interface. This enables you to manage the
ONE100D/M locally. For more information, refer to
4.7 - Console port specifica-
tions on page 46 .
ETHERNET
SWITCH, E0-0/0
... E3-0/3
These RJ45 connectors are the Ethernet LAN connectors. There are 1+4 Ethernet
LAN connectors on the ONE100D/M.
The separate Ethernet interface can be used as main WAN link or as a back-up
WAN link interface. The Ethernet switch is VLAN manageable.
Connect one side of an Ethernet LAN cable (not included) to the LAN connector of
the ONE100D/M and the other side to an Ethernet network outlet. Each LAN inter-
face supports 10/100 Mbps auto-sense and auto cross-over.
Refer to 4.4 - LAN interface specifications on page 43 for the pin lay-out of this con-
nector.
WLAN The WLAN antennas are installed in the factory. Please raise them in a vertical
position.
ISDN-BRI
L0-5/0 ... L7-5/7
These RJ45 connectors are the ISDN connectors. The number of ISDN connec-
tors will vary depending on the model of the ONE100D/M.
Connect one side of an ISDN cable (not included) to the ISDN BRI connector(s) of
the ONE100D/M and the other side to an ISDN outlet.
Refer to 4.2 - ISDN interface specifications on page 39 for the ISDN specifications
of this connector.
FXO
Lx-5/x
This RJ45 connector is used to connect the telephone line.
The ONE100D/M with FXS and FXO interfaces have got an earth stud. This must
be permanently connected to the main protective earth.