3
English
Auto Code Search
The Auto Code Search goes automatically through all the codes
for the device you’re trying to control. When you find the one
that operates your device, you can stop the search and store
that code.
TIPS:
4OPROGRAMTHE!58OR!58KEYSYOUMUSTlRST
assign them to a device type. See the
Assigning the AUX1 and
AUX2 Keys
section.
%ACHDEVICEKEYISASSOCIATEDWITHATYPEOFDEVICETHE46IS
PRESETTOSEARCHFOR46S3!4s#",s$4#FORSATELLITERECEIVERS
DIGITAL46CONVERTERSORCABLEBOXES$6$FOR$6$PLAYERS
$62FOR$62S!5$)/FORAUDIORECEIVERSAND6#2FOR6#2S
4OCONTROLCOMBODEVICESLIKE46$6$SAND466#2SYOUNEED
TOPROGRAMEACHKEYSEPARATELY%ACHKEYWILLCONTROLTHATPART
OFTHECOMBODEVICE
)FTHEORIGINALREMOTECONTROLTHATCAMEWITHYOURDEVICEHAS
SEPARATE/.AND/&&KEYSINSTEADOFASINGLE0/7%2KEY
THE!UTO#ODE3EARCHMIGHTNOTWORKWITHTHATDEVICE4RYTHE
$IRECT#ODE%NTRYMETHODDESCRIBEDLATERINTHISMANUAL
4OEXITWITHOUTSAVINGANEWCODEATANYPOINTINTHE!UTO
#ODE3EARCHPRESSTHE%8)4KEY
1.
Manually turn on the device you want to control.
2.
Press and hold the device key you want to program (the
POWER key illuminates). While you’re holding down the device
key, use your other hand to press and hold the remote’s POWER
key at the same time (the POWER key turns off).
3.
Wait until the POWER key comes on and stays on. Then
release both keys.
4.
Point the remote directly at the front panel of the device you
want to control. Press SLOW on the remote and wait 5 seconds.
The remote is testing a batch of 10 codes on your device.
Did your device turn off?
YES:
Go to step 5.
NO:
Press SLOW again. The remote tests the next batch of
10 codes.
Keep pressing SLOW every 5 seconds until your device turns
off.
5.
When your device turns off, press the SKIP BACK key on the
remote and wait at least 2 seconds. The remote tries the
last of the previous ten codes.
Did your device turn on?
YES:
Press the OK key. You’re done! You’ve programmed
this device key.
NO:
Press SKIP BACK again. The remote tests the next code
in the batch.
Keep pressing SKIP BACK every 2 seconds until your device
turns back on. When it does, press OK.
Note:
If you accidentally press the SKIP BACK key after your
DEVICETURNSONPR)0&7$KEY4HENWAITTWOSECONDS
to see if your device turns off again.
NOTES:
4HROUGHOUTTHEPROGRAMMINGOFEACHKEYBESURE
to keep the remote pointed at the IR sensor of the device you
are currently programming the remote to control.
