4.
Depending on your desired mic/antenna
position, screw the two security lugs into either
the two inner or the two outer holes of the
bracket and threaded insert.
8.
(a) To mount the
mic bar on a mic
stand
, align the socket
of the center bracket
with the threaded end
of the mic stand shaft.
Screw the mic stand
shaft into the socket.
7.
Repeat step 6 for the
remaining three multi-position
mounting lugs.
6.
Loosen one multi-position mounting lug by turning the upper knurled cylinder counterclockwise until the
lower sliding block can travel freely through the mic bar. Insert the lower sliding block into the end of the mic
bar, leaving the metal washer above the mic bar track so that the lower sliding block is the only part inside the
bar. Slide the mounting lug to your desired mic/antenna position and tighten the mounting lug by turning the
upper knurled cylinder clockwise to secure it in place.
Questions or Concerns?
Contact the Customer Service Department at [email protected] or call us at 800.289.8889
5.
Screw the two center bracket mounting
lugs into the remaining two holes of the
center bracket and threaded insert
8. (b) To mount the mic
bar on a speaker stand
,
screw the speaker stand
adapter into the socket of
the center bracket. Slide
the socket of the speaker
stand adapter over a 1
3/8” speaker stand pole
mount and tighten the
knob on the adapter.
9.
Mount mics (clips not included), antennas, or anything
with a compatible 5/8”-27 threaded base to the six
mounting lugs. Reference the weight capacity of the mic
stand or speaker stand to avoid overloading.
