LIBRETTO ISTRUZIONI - INSTRUCTION MANUAL
T
he user manual provided is an integral part of the product and must be read with care, as it contains important
instructions on use and maintenance.
T
his manual must be kept and made available to other future users.
T
he
SW200-250 - 350 geared motor is designed for the motion of hinged gates.
I
t is forbidden to use the product for
purposes other than those specified or for improper purposes.
A
ny other use is considered improper and poten-
tially dangerous.
I
t is forbidden to tamper with or make changes to the product.
D
o not allow children to play or
stand within the operating radius of the automation.
K
eep the motion activation devices under control in order
to prevent involuntary activation by children or other people.
T
he automation can be controlled by people who
are 8 years old and older and by people with reduced physical, sensory or mental capabilities, or the necessary
knowledge provided that they are supervised or have received instructions regarding the safe use of the automa-
tion and understand the inherent dangers.
C
hildren must not play with the automation.
T
he cleaning and main-
tenance to be carried out by the user must not be done by children without supervision.
S
upervised children
must not play with the automation.
I
t is recommended to contact the installation company and prepare a routine
maintenance schedule, as required in accordance with the applicable standards (within the EEC: Machine Direc-
tive 2006/42/EEC).
P
erform correct routine maintenance referring to the maintenance booklet provided by the
installer.
T
he connection, testing and commissioning of the system, and all periodic checks and maintenance work,
including cleaning of the drive, must be entrusted to specialist technicians trained in the use of the product.
F
requently check the motion, verify any signs of use or damage of the cables, in this case or in case of failure or
irregular operation, turn off the power to the automation at the main switch.
D
o not attempt to make changes or
repair the main system; for these purposes, contact the person who installed the automation, or another special-
ist installer.
F
ailure to observe this requirement can be dangerous.
T
he user is not permitted to either service the
system and control equipment, or access the electrical box.
I
n the event of a malfunction or power failure, it is
possible to activate the MANUAL RELEASE as follows:
Insert the key supplied and turn 90° counter clockwise to unlock it manually; remove the lock,
insert the hex key and turn 180 ° (see figure 9).
A
ctuation of the manual release can cause uncontrolled movement of the driven part due to the mechani-
cal parts, failure or a state of imbalance. Therefore, it is recommended to fully open the gate and to restore the
manual release after actuation.
FIGURA 9
FIGURE 9
8
A
B
C
