9051_Bedienungsanleitung_C1_Rev2_EN_UK – Stand 08.08.2018 TS / MB
10
4
Assembly
Use only screws that correspond to the enclosed base drawing for the assembly of your desk base.
Attention:
Incorrect screws can cause damage to the desk.
Danger:
The power cable of the motor controller must be disconnected during assembly of the
desk base!
Attention:
Before assembly and commissioning of the FREE.STAND sit/stand desk, make sure
the product is acclimatised for the temperature and relative humidity values stated in the technical
data!
4.1 Installing the crossbeams and table-top supports or the upper frame
Now fit the two longitudinal spars on the two side frames. Ensure that you have first positioned the lugs of the
table-top supports aligned to the crossbeams.
Use only the M6 screws according to the support frame drawing to do this.
The maximum tightening torque for these screws is 7.5 Nm.
The maximum screw-in depth into the motor housing is 10 mm.
Crossbeam
Screw M6
as per the support frame
drawing
Mounting leg
Table-top
