![background image](http://html1.mh-extra.com/html/omron/v690-series/v690-series_user-manual_741403088.webp)
5-8 Antenna Operation Command
5-32
5-8-2 Reset
Resets an antenna. It takes approximately 2 seconds to reset.
Resetting:
• Clears data read out of a tag at polling. A response is not returned by the Request to Response (H0) command.
• Clears the immediately preceding response. A response is not returned by the Request to Retransmit (H1) command.
• Changes the Radio Wave Transmission ON mode into the OFF mode.
• Enables the host communication condition setting (Section 5-9-7) and station number setting (Section 5-9-8) commands.
<Command Format> * A figure below shows the number of characters.
<Response Format>
There is no response format.
DA
Operation mode
Destination (antenna) station number. "00" to "31". This
can be modified in "5-9-8 Station Number Setting".
Initial value "00"
Setting mode
"99"
SA
Source (host device) station number. "80" to "89". If only one host device is used, specify "80".
Command code
C0
Command
code
(BCC)
* It can be specified whether BCC is enabled or disabled.