TM Conveyor Tracking
Software version: TMflow 1.76
23
Get:
automatically obtains the
corresponding position values in all
identification points: X, Y. Z, Rx, Ry, and
Rz.
OK:
saves result and returns to the
previous page.
Other CVPoint settings are the same as the
parameters in Point Node.
Figure 15 Get Point
NOTE
：
If the Get Point values are unreasonable, users have to recalibrate their part location (calibrate
for Sensor Mode, and save new source image in the vision job for ETH Mode).
If the project has CVPoint Node with pre-obtained values, users may just enter values to update
the pre-obtained values when adding a new CVPoint Node. Then click OK to save the results.
Analog/Digital IO could be set to control the component to grip/release or other implementation
before the Follow Time of CVPoint.
