![background image](http://html1.mh-extra.com/html/omron/sysmac-c200h-asc02/sysmac-c200h-asc02_operation-manual_742429080.webp)
70
Page
Command
Purpose
66
address
Displays/changes memory contents at the specified
address.
68
M
Transfers memory contents.
69
C
Compares memory contents.
69
R
Displays/changes register contents.
70
BP
Sets/displays breakpoints.
70
N
Clears breakpoints.
71
I
Disassembler
71
S
Outputs data to a port.
72
L
Loads data from a port.
72
V
Verifies data.
73
G
Executes a program.
73
T
Single-step program execution
74
Mini-Assembler
Single-line assembly
74
Arithmetic
Addition/subtraction of hexadecimal numbers.
DUMP Command
Purpose:
To display the contents of memory in hexadecimal
Format:
[(display start address)].[(display end address)]
Remarks:
If the carriage return
↵
is input by itself, eight bytes of data starting from the
base address will be displayed. (refer to example 2)
If an address is entered preceded by a period, e.g., “.3000”, data stored in all
the addresses from the base address to the entered address will be dis-
played (refer to examples 3 and 4).
New data can be stored in memory as well; this data will overwrite existing
data. Input data must be in hexadecimal. Upper case characters must be
used for the alphanumeric values of A through F (hex). When the leftmost
digit is a “0”, it can be omitted.
There are two ways to poke data (directly store data to a specific address).
1, 2, 3... 1.
Specify the first address followed by a colon. Directly after the colon,
enter the data (1 or 2 byte hexadecimal values only) separated by
spaces. Then type a carriage return (refer to example 5).
2.
Enter a colon followed by the data and type a carriage return. Data will
be stored starting from the base address (refer to example 6).
Examples:
1.
Enter:
*4000
↵
Displayed:
4000-10
•
Displays 1 byte of data from the specified address.
2.
Enter:
*
↵
Displayed:
*20 30 50 60 70 80 90 9F
•
Displays 8 bytes of data, starting from the base address.
3.
Enter:
*.4010A
↵
Displayed:
4008-A0 B0 C0 D0 E0 F0 00 10
Monitor Mode Commands
Section 5-3
Содержание SYSMAC C200H-ASC02
