Omron NJ501-5300, Инструкция и справочник, Страница: 59 / 142

2 - 21
2 G Code
NJ/NY-series G code Instructions Reference Manual (O031)
G61 Exact
Sto
p
Mod
e
2
Parameters
G61 Exact Stop Mode
This instruction stops operation between blocks to prevent corner blending from being executed.
This command does not have any parameters to set.
The G61 stops an operation between blocks to prevent the execution of blending of the corner and cut-
ting corners with an acute angle during operation. When G61 is commanded, deceleration is applied to
the end point of the cutting block, then an in-position check of each block is executed. G61 maintains
the valid state until G64 (Continuous-path Mode) is commanded. Continuous-path Mode (G64) is the
default value at startup.
Refer to the programming example of G64 Continuous-path Mode on page 2-22.
Modal/Non-modal Modal
Modal group 15 Path Control
Instruction format G61
Relevant G codes G01, G02, G03
Parameters
Function
Programming Example