Omron M12 -, Техническое описание

Страница: 17 / 31

XS5
18
•
Tentatively insert the pins to the pin block holes so that the key on
the pin block will coincide with the key groove on the pin clamp.
Then insert the cable along with the pin clamp.
•
Loosen the screws on pins 1 to 4 and insert the cores according to
the pin numbers.
•
Use the dedicated Screwdriver (XW4Z-00B)
*
and tighten the
screws securely so that the cores do not pull out (tightening torque:
0.15 to 0.2 N·m).
•
Five-pole Connectors
•
Strip the cable sheath for a total of 15 mm and strip the core
covering for 8 mm for the core to connect to pin 5.
•
Connect the core to pin 5 (in the center) first.
•
Insert the core from the side of the hold with the tab and tighten the
screw securely (tightening torque: 0.15 to 0.2 N·m), and then cut
off the excess wire with wire cutters.
•
Bend the cable as shown below, attached the enclosed insulation
cap, and then strip the other cores.
•
Connect the cores to pins 1 to 4.
Connecting Shielded Cables to Five-pole Connectors
•
Place the insulation tub on the drain line of the shield and connect
it to the terminal.
•
Tighten the screw and then check visually to see if there is
insulation between the cores.
•
Connect the cores to pins 1 to 4.
*
When tightening the screws, use the dedicated XW4Z-00B
Screwdriver that matches with the screw-slot dimensions.
(4) Inserting Pin Block
•
Mount the cover to the pin block so that the triangle mark on the pin
block will coincide with the triangle mark on the cover.
•
If the cover is used for an Angled model, the relationship between
the position of the polarity key on the engaged side and cable
connection direction will be determined by the direction in which
the positioning key is inserted into the cover, which can be rotated
by 90
°
.
•
Fully insert the positioning key until the positioning key is hidden by
the casing.
Screw-on Connectors
Pin Block Pin Clamp
Key groove Key groove
Key
XS5C use XS5G use
6 ±
0.5
Insertion
8
12
12 ±
0.5
Cable End Processing
•
Four-pole Connectors
8 7
8
12
Conductors for
pins 1 to 4
Conductors for
pin 5
Screw
Dedicated
screwdriver
Dedicated
screwdriver
Screw
Tab
Insulation cap
Insulation tube
Drain line
XW4Z-00B
Screwdriver
Lock spring
O-ring
Triangle mark
Positioning key
(triangle mark)
Polarity key
Pin Block
(Soldering Model) Cover
(Straight Model)
(Crimping Model)
(Angled Model)