Omron FHV Series, Руководство по установке

Страница: 98 / 164

4-1 Warning
WARNING
This product must be used according to this manual and the instruction sheet.
Failure to observe this may result in the impairment of functions and performance of the
product.
Please do not use this product to directly or indirectly use to detect the human body for the
purpose of ensuring the safety.
Precautions for Safe Use
Installation Environment
• Do not use the product in areas where flammable or explosive gases are present.
• Do not install the product close to high-voltage devices and power devices in order to secure
the safety of operation and maintenance.
• Do not install the product to a place where vibrations and/or impacts are expected.
• Do not install the product near to a device causing noises. if the product is installed in a noisy
environment and operational errors are caused, be sure to take shielding measures.
Precautions for Correct Use
Installation Location
In order to prevent the product from becoming inoperable or malfunction, and to prevent other
adverse effects to the performance or equipment, please observe the following.
• A location where the ambient temperature does not exceed the rated range (operating: 0 to
40°C, storage: -25 to 65°C).
• A location where the temperature does not vary sharply (condensation occurs).
• A location where relative temperature does not exceed a range of 35-85%RH.
• A location not exposed to corrosive gases or combustible gases.
• A location not exposed to dust, salt, or metal powder.
• A location not exposed to direct vibration or impact.
• A location not exposed to strong disturbance light (laser light, arc welding light, or ultraviolet
light).
• A location not near a heating appliance or exposed to direct sunlight.
• A location not exposed to mist of water, oil, or chemicals or misty atmosphere.
• A location not exposed to strong magnetic/electric fields.
• A location not near a high-voltage device or power device.
• A location where rubber quality is not deteriorated.
MicroSD Card Handling
• If removing the microSD card, confirm that data are not being read or written before removing
it.
• Do not insert the microSD card inversely, obliquely, or as twisting it.
• While data are being read in or written to the microSD card, the SD ACCESS LED on the
smart camera main unit is turned on for a while. Remove the card after checking that the LED
is completely turned off.
• Except when inserting or removing the microSD card, put the cover of the microSD card in-
serting connector and screw it up before using the product.
Camera Installation
• In an environment exposed to high humidity and sharp temperature fluctuation, the inside of
the lighting cover may become cloudy in rare cases. If it becomes cloudy, remove the lighting
cover and wipe off the inside with a soft cloth.
• If installing smart camera main units side by side, secure a space of 30 mm or more wide
between them.
4 Handling and Installation Environment
4 - 2
FHV Series Smart Camera Setup Manual (Z408-E1)