3
E3Z-H
Rating/performance
Item
Through-beam
Retro-reflective with
M.S.R.
Diffuse-reflective
wide-beam
standard-beam
NPN output E3Z-T61H/T66H
E3Z-R61H/R66H
E3Z-D61H/D66H
E3Z-D62H/D67H
PNP output E3Z-T81H/T86H
E3Z-R81H/R86H
E3Z-D81H/D86H
E3Z-D82H/D87H
Sensing distance
15 m
4 m (100 mm)
*1
*
(When using the
E39-R1S)
*1.
Values in parentheses indicate the minimum required distance between the sensor and reflector.
100 mm
(White paper
100 x 100 mm)
1 m
(White paper
300 x 300 mm)
Standard sensing object
Opaque: 12-mm dia.
min.
Opaque: 75-mm dia.
min.
---
Differential distance
---
20% max. of sensing distance
Directional angle
Both emitter and
receiver: 3° to 15°
2° to 10°
---
Light source (wave length)
Infrared LED (860 nm)
Red LED (680 nm)
Infrared LED (860 nm)
Power supply voltage
12 to 24 VDC ±10%, ripple (p-p) : 10% max.
Current consumption
emitter: 15 mA
receiver: 20 mA
30 mA max.
Control output
Load power supply voltage 26.4 VDC max., load current 100 mA max. (residual voltage 2 V max.) Open
collector output type (depends on the NPN/PNP output format), Light-ON/Dark-ON selectable by wiring
Protective circuits
Protection from load
short-circuit and re-
versed power supply
connection
Reverse polarity protection, output short-circuit protection, mutual interference
prevention, output reverse protection
Response time
Operation or reset: 1 ms max.
Sensitivity adjustment
no adjustment
Single-turn adjustment
Ambient illuminance
Incandescent lamp: 3,000 lux max. Sunlight 10,000 lux max.
Ambient temperature
Operating: -25°C to 55°C, Storage: -40°C to 70°C (with no icing or condensation)
Ambient humidity
Operating: 35% to 85% RH, Storage: 35% to 95% RH (with no icing or condensation)
Insulation resistance
20 M
Ω
min. at 500 VDC
Dielectric strength
1,000 VAC at 50/60 Hz for 1 minute
Vibration resistance
10 to 55 Hz, 1.5-mm or 300m/s
2
double amplitude for 2 hours each in X, Y, and Z directions
Shock resistance
Destruction: 500 m/s
2
for 3 times each in X, Y, and Z directions
Degree of protection
IEC 60529 IP67, IP69k after DIN 40050 part 9
Connection method
Pre-wired (standard length: 2 m/500 mm)/M8 connector
Indicator lamp
Operation indicator (orange), stability indicator (green) [Note that the emitter has the power indicator
(orange) only]
Weight
(Packed
state)
Pre-wired
models (with
2-m cable)
Approx. 120 g
65 g
Connector type
30 g
Approx. 20 g
Material
Case
PBT (polybutylene terephthalate)
Lens
Methacylate resin
Accessories
Instruction manual (The Reflector or Mounting Bracket is not provided with any of the above models.)
