4
. UPS functions
32
This function notifies you with LCD and beep sound when the battery needs to be replaced. The bat-
tery life counter operates while commercial power is supplied after shipment. (When the ambient
temperature of the battery is higher than 25°C, the value of the counter will be incremented at a faster
pace.)
When the battery needs to be replaced, the battery replacement lamp will light up and beep will sound.
* Be sure to reset the battery life counter after replacing the battery.
4-3 Battery life counter function
4-4 Operation panel setting
A list of menu items on the LCD is shown in the table below. Menu items displayed vary depending on
the menu type setting.
The menu type can be set with “Settings” - “Local Settings” - “Menu Type”. There are two types of
menu: “Standard Mode” (for general users) and “Advanced Mode” (for administrators).
<Meaning of the Note column>
*1: Displayed only when the menu type is “Advanced Mode”. (Not displayed in “Standard Mode”.)
*2: The setting can be changed only when the UPS is stopped. During operation, the setting can be
checked but not changed.
Menu
Description
Note
Measurements
Load Meter
Display the applied load in VA and W.
Input/Output
Display the input/output voltage and
frequency.
Battery Meter
Display the status of the built-in battery.
Longevity
Display the estimated lifespan of the
UPS in 5 levels.
Efficiency
Display the efficiency of the UPS as a
percentage.
*1
Cumulat. Power
Display the amount of power used so
far and the number of days elapsed.
*1
Average Power
Display the average amount of power
used so far.
*1
Control
Function Test
Perform a self-diagnosis and a test to
check for battery deterioration, and
then display the results.
ResetB.L.cnt
Reset the battery life counter.
Reset Failure
Reset a failure.
ResetPow.Usage
Reset the values of cumulative power
usage and average power usage.
*1
DryContactTest
Perform a contact signal test.
*1
*2
Maintenance
Move to Bypass Mode forcibly.
*1
Initialization
Return each of the UPS settings to the
factory settings.
*1
*2
