BU
2002
RWLG/BU
3002
RWLG/BU
5002
RWLG
2
17
When using the included UPS monitoring software or the contact signal, use the connection cable to
connect the unit to the PC.
2-3-3. Connecting to a computer
See also
“7. Using the UPS monitoring software and Contact Signal” on page 38.
* If you do not use the UPS monitoring software and Contact Signal, this step is not required.
(2) Attach the terminal block cover (with cable clamp) to the unit.For BU2002RWLG and BU3002R-
WLG, attach the cover after connecting the input cable.
BU2002RWLG/BU3002RWLG
Insert the upper part of the terminal block cover into the slit of the unit, and tighten it with two of
the included M3 screws.
Tighten the cable clamp dial to stabilize the wire.
G
L2
L1
G
L2
L1
INPUT
1
φ
170-278 VAC
50-60 Hz 15 A
OUTPUT
1
φ
100/200/208/
220/230/240 VAC
50-60 Hz 15 A
BU5002RWLG
Insert the tab on the left side of the terminal block cover into the slit of the input terminal block cov-
er, and then run one of the included M3 screws through the hole on the right side of the terminal
block cover and tighten it.
Tighten the cable clamp dial to stabilize the wire.
INPUT
G
L2
L1
G
L2
L1
OUTPUT1 25 A
