![background image](http://html1.mh-extra.com/html/omron/bu1002swg/bu1002swg_instruction-manual_744587080.webp)
67
7
BU
1002
SWG / BU
3002
SWG
7-4 Contact signal (SC08G: PNP output)
"SC08G" is a contact signal I/O card dedicated for Omron uninterruptible power supply (UPS).
The SC08G can stop the UPS by outputting power outage and low battery level signals, and inputting an
UPS stop signal from the outside.
Contact Omron representative for the latest compatible models.
1. Accessories
SC08G card unit........1
Remote ON/OFF connector (Attached to the card unit) ........1
Dsub-9 pin plug........1, Compliance information sheet ........1
2. Name of each part
The figure below describes the name of each part of the SC08G.
3. Installation of the SC08G
UPS Connection terminals
Remote ON/OFF connector
Signal I/O connector
Caution
Before commencing the work, be sure to turn off the UPS,and pull out
the “AC Input” plug from the commercial power outlet.
When inserting or removing this card unit, turn off the uninterruptible
power supply (UPS) main body and connection apparatus, and then
pull out the “AC Input” plug from the power receptacle.
●
Failure to do so may cause electric shock.
When you perform attachment and removal of this card unit to an
uninterruptible power supply (UPS), please work by installing an unin-
terruptible power supply (UPS) in the stable place in a direction that is
fall-proof. In addition, be care not to drop the unit.
●
Dropping or toppling the card unit may cause injury.
●
If you drop the unit, stop using it and have it inspected and repaired. For repair, contact the
shop of purchase.
Securely ground the UPS in which the card unit is installed.
●
If the UPS unconnected to a ground wire and another device contact at the same time, an
electric shock may be caused.
Do not touch parts on the board end face or the board when installing,
unpacking, removing the card unit.
●
Contact with the sharp board end face or any part may cause injury.
●
Contact with any hot part may cause burns.
●
The card unit uses electrostatic sensitive parts. Therefore, do not touch the connector contact
port and other parts with bare hands in particular.