Omron 3G3EV-A2001-CUE, Руководство по установке

Страница: 44 / 55

4-4
H
Control Characteristics
Control method Sine-wave PWM method (automatic torque boost)
Frequency control range 0.5 to 400 Hz (standard model: 1.5 to 400 Hz)
Frequency accuracy
(temperature fluctuation) Digital command:
±
0.01% (–10
°
C to 50
°
C)
Analog command:
±
1% (25
±
10
°
C)
Frequency setting
resolution Digital command:
0.1 Hz (less than 100 Hz), 1 Hz (100 Hz or more)
Analog command:
0.06 Hz (60 Hz)
Frequency output resolution 0.1 Hz (operation resolution)
Overload resistance 1 minute or less when 150% of rated output current is received
Frequency setting signal 0 to 10 VDC (20 k
Ω
) or 4 to 20 mA (250
Ω
)
Note This setting can be switched using the internal DIP switch.
Acceleration/Deceleration
time 0.0 to 999 seconds (acceleration and deceleration times are set separately)
Braking torque (continuous
regenerative braking) Approximately 20%
Note 125% to 220% when braking resistor is externally installed.
Voltage/Frequency
characteristics Simple V/f pattern setting
H
Protection Functions
Motor protection Electronic thermal protection
Instantaneous overcurrent
protection When 250% of the rated output amperage is exceeded
Overload protection When 150% of the rated output amperage is exceeded for one minute
Overvoltage protection Stops the system when DC voltage of the main circuit exceeds
approximately 410 V (400-VAC class: 820 V)
Voltage drop protection 3G3EV-A2
j
: Stops the system when voltage drops below approximately
200 VDC
3G3EV-AB
j
: Stops the system when voltage drops below approximately
160 VDC
3G3EV-A4
j
: Stops the system when voltage drops below approximately
400 VDC
Protection from
instantaneous power
interruption Stops the system when a power interruption lasts for 15 ms or more.
Operation can be continued by setting constant No. 36 as follows:
•
Operation is continued if a power interruption only lasts for approximately 0.5
second or less.
•
Operation is continued unconditionally.
Radiation fin overheat
protection Detects a fin temperature of 110
±
10
°
C
Ground protection Overcurrent level protection
Specifications
Chapter 4