surface and are centered on the hinge line. Clean off any excess glue and tape the elevators in place while
the glue dries.
10. Now locate the carbon fiber horns (4) two for each side. Locate the two slots in the elevators and carefully
remove the covering to expose the slot on the bottom only. Prepare the horns the same way as the rudder
horns and glue in with epoxy or thin CA.
11. Now install the ailerons using the supplied hinges and the same technique as you did for the rudder and
elevators. Double check the operation and tape the ailerons in place until the glue cures. Install the control
horns in each wing likewise using the same technique as the previous surfaces.
