00061967.DOC, Version 1.0
60/72
7.4 Basic adjustment of the mixer
Virtual DJ
TMC-2 MK2
1
For basic adjustment set the master controls [
MASTER CONTROL
] and [
MASTER LEVEL
], the
[
crossfader
] and in both channels the [
GAIN
] controls and the [
equalizers
] to mid-position.
2
Advance the two [
channel faders
] approx. to 2/3 of the maximum for sufficient way for fading in and
out.
3
Play a title with Deck A and control the deck with the respective [
GAIN
] control according to the level
indication. An optimum level control is obtained if level values in the 0 dB range are shown at average
volume. If the red LEDs of the [
output meter
] light up, there is an overload of the channel. Stop the
playback on Deck A and adjust Deck B in the same way.
4
Adjust the desired sound with the tone controls of the channel. By adjusting the three tone controls, the
high frequencies (control [
HIGH
]), the midrange frequencies (control [
MID
]), and the low frequencies
(control [
LOW
]) can be boosted or substantially attenuated. With the controls in mid-position, the
frequency response is not affected. Sound adjustments affect the level. Readjust the channel level with
the [
GAIN
] control, if necessary.
5
Adjust the low frequencies for the output signal at the balanced master output with the control [
BASS
LEVEL
].
6
Adjust the definite level of the output signal at the master outputs with the controls [
MASTER
CONTROL
] and [
MASTER LEVEL
].
7
Adjust the desired signal level for the output [
BOOTH
] with the control [
BOOTH VOLUME
].
8
The recording signal at the recording output [
REC
] is taken off ahead of the output controls, i.e. it is not
affected by the controls [
MASTER CONTROL
], [
MASTER LEVEL
] and [
BOOTH VOLUME
].
7.5 Crossfading between the decks
1
The [
CROSSFADER
] allows crossfading between both decks:
• crossfader moved to the left: fade-in of Deck A and fade-out of Deck B
• crossfader moved to the right: fade-in of Deck B and fade-out of Deck A
• for hearing the signals of the two decks at the same level, set the crossfader to mid-position
2
The characteristic of the crossfader can be adjusted with the control [
X-FADER CURVE
]:
• left position: smooth crossfading (gradual transition ) e.g. for long mixes
• right position: sharp crossfading (abrupt transition) e.g. for scratching and cutting.
Note
•
Do not use the control [
X-FADER CURVE
] while a signal is present as this may cause a sudden
change in volume.
Содержание TMC-2 MK2
Страница 2: ...00061967 DOC Version 1 0 2 72...
