10006750_V_1_1.DOC
26/28
Rear panel
1. AC CONNECTION
Plug in the power supply cable here.
2. POWER SWITCH
Press this button to start operating.
3. MASTER OUT 1
Output sockets (RCA and XLR) for connecting your power amplifier.
4. MASTER OUT 2
Output sockets (RCA and XLR)
for connecting your power amplifier.
5. BOOTH
Connect your monitor system here via RCA and ¼" jack plugs.
6. REC OUT
Connect your recording unit here via RCA plugs.
7. LINE / PHONO / MIC INPUT-SOCKETS
RCA and ¼" jack sockets.
Connect your line sources like CD, MP3, MD, DAT, Tape Decks with LINE input-sockets. Line level musical
instruments with stereo outputs such as Rhythm Machines or Samplers should also be connected with the
LINE input-sockets. Make sure that the PH/LINE/ LINE or LINE/MIC-switch is set to LINE.
You can use the PH/LINE input-sockets either for connecting your turntables equipped with MM pickup
cartridge or for line sources. Set the PH/LINE switch accordingly.
Connect your microphones with the ¼" jack sockets. Make sure that the LINE/MIC-switch is set to MIC.
8. GND (Ground terminal)
Connect the ground lead of the turntable with this terminal. This helps to reduce humming and pop noises.
9. PH / LINE-SELECTOR
Used to switch the input sockets of CH-1 and CH-2 to Phono or Line.
10. DJ MIC-SOCKET
Connect your microphone with ¼" jack plug here. If the rear socket is in use, the REAR MIC IN-LED on the
front panel lights up.
11. MIC LEVEL / LINE LEVEL-SELECTOR
Used to switch the DJ MIC socket to Mic or Line.
12. MIC / LINE-SELECTOR
Used to switch the input sockets of CH-3 and CH-4 to MIC or Line.
13. OUTPUT LEVEL-SELECTOR
Used to switch the output level to 0.75V or 1.5V.
