10040204_V_1_0.DOC
20/24
5.2.6 Master section HRS-1002 and HRS-12002
PHANTOM (+48V)
With this switch, you can activate the phantom power for the XLR-
sockets of the mic channels. The phantom power is needed for
operating condenser microphones. Connected dynamic micro-
phones may be operated if they are balanced. If in doubt, please
contact your microphone manufacturer.
The phantom power must only be activated if all microphones
are connected and all output controls are set to minimum
position. During the stabilization phase (approx. 1 minute), you
must not connect or disconnect any mics or adjust output
volumes. Otherwise danger of speaker damage.
+48V LED
This LED lights to indicate that the phantom power is on.
POWER ON LED
This LED lights to indicate that the unit is connected to the mains
and powered on.
LEVEL METER
This 4-segment display shows the level of the left and right Master
output.
Input level setting
Every input channel should be adjusted to the same level, so that
an even sound can be reached. Follow this procedure for every
input channel:
Turn the LEVEL control to center position and apply a typical
audio signal to this channel. The -20 dB LED should flash. Then
turn the TRIM control to the right until the LED meter flashes at 0
dB. When CLIP LED flashes, the input signal is distorted. Turn the
TRIM control to the left to reduce the preamp level until the LED
does not light anymore.
A recording level of 0 dB is recommended for all signal types.
SEND
With the SEND control, you can control the signal sent to the SEND socket.
TAPE LEVEL
With the TAPE LEVEL control, you can adjust the signal level of the TAPE input
channel.
PHONES LEVEL
The PHONES LEVEL control adjusts the volume of the headphones output.
MAIN MIX
The MAIN MIX fader adjusts the volume of the MAIN OUT jacks.
