10602298_V_1_0.DOC
29/68
Connect the CD-player with the RCA-cable to your mixer via the Audio Out-sockets. Make sure that the
right/left occupation (plug-colour red/white) is the same at both devices.
CAUTION:
Make sure that the CD-player is switched off (power-switch in outer position) before you connect
it to the mains in order to avoid damages on your loudspeakers.
Make sure that the indication on the Voltage-selector corresponds to the available voltage in order to avoid
severe damages.
Connect your CD-player with the mains.
CAUTION:
Turn the amplifier on last and off first!
6. OPERATION
6.1 Setup
Switch the CD-player on via the Power-switch.
When the device is on and the tray has no disc, "NO DISC" appears on the display.
6.2 CD-tray
Press Open/Close-button in order to open the disc tray. The CD-tray opens, the status-LED flashes and the
display shows "OPEN".
Insert your CD in the CD-tray. Make sure that you only hold the CD with 2 fingers on the edge. Avoid
touching the inside area of the CD.
CAUTION:
Do not close the tray by pushing it as this could harm the construction.
Press the Open/Close-button again in order to close the tray. The status-LED flashes until the tray is closed.
The LED is turned off and the player is ready for operation.
6.3 LCD-display
If the CD is improperly positioned,"ERR" or "NO DISC" appears on the display.
If the CD is properly positioned, the CD-player reads the CD.
The player jumps to the first track and is in the Pause-mode (Pause-symbol flashes).
Please note that the player automatically jumps to the section where the music starts.
Avove "track“ the track number is displayed. The track remain time is displayed in M
(MIN), S (SEC) and F (FRAME).
By using the Time-button, the time-indication can be switched from track remain time
(Remain) to total remain time (Total Remain) to track playback time (Elapsed).
Above the time-indication, 10 bars are displayed showing the remaining track-time
visually. The shorter the track remain time becomes, the less bars are displayed. 15
seconds before the track-end, the bars in the display start flashing.
By pressing the SGL/CTN-button, the CD-player is put into Single-mode and the display shows "SINGLE".
The indication "0.0" means that the playback-speed has not been changed. If you adjust the playback-speed
via the Pitchfader (Pitch-LED of the selected speed is flashing), the respective percentage is indicated in the
display.
6.4 Play/Pause
In the Pause-mode the the time-indication in the display stands still and the Play/Pause-LED flashes. The
playback of the first track can be started by pressing the Play/Pause button. In the Playback-mode, the time-
indication in the display is running and the Play/Pause-LED shines permanently.
If you wish to interrupt the playback, press the Play/Pause-button and the laser stops at the position where
you stopped.
Содержание DJS-1150
Страница 2: ...10602298_V_1_0 DOC 2 68 37 38 39 35 36...
