25
•
EN
USB Devices and Memory Cards
Insert a USB device into the USB port and/or a memory card into the card slot. The display indicates “
USB
“
or “
SD
“. After loading a data carrier, it is selected as the playback medium and the playback will start
automatically. Use the remote control to operate the music conveniently from a distance.
Tuner Mode
Long actuation of the button [►
] starts the automatic station memory. The automatic station memory will
be running forward and stores stations with good reception. Stored stations can be called with the buttons
[
] and [
]. For direct selection of a station use the numerical keys [0-9] on the remote control.
Remote Control
When actuating a button, always direct the remote control towards the sensor. There must be no obstacles
between remote control and the sensor.
Button
Function
►
Play/pause or auto station memory
CH- / CH+
previous/next radio station
EQ
Equalizer settings
─ / +
Volume down/up
0-9
Direct title or station selection
/
Short actuation: previous/next title
Long actuation: fast rewind/forward
ENTER
Repeat functions one/ran(dom)/all
MODE
Switches between USB/SD/Bluetooth/FM tuner
Notes
•
The remote control is supplied with a battery inserted. An insulating foil between the battery and the battery
contacts prevents the battery from being discharged during storage. Prior to the first operation remove the
foil from the battery support on the rear side of the remote control. Otherwise operation of the remote
control is not possible.
•
If the range of the remote control decreases, replace the battery. For this purpose,
on the rear side of the remote control press the small bar with the groove to the
right and at the same time remove the battery support. For operation, one 3 V
button cell type CR 2025 is required. When inserting, pay attention that the
positive pole of the button cell shows upwards in the support.
•
Remove the battery from the remote control as a precaution if the device is not used for a longer period of
time.
Protective Circuits
The protective circuits prevent damage to the speakers and the amplifier. If activated, the speakers are
electrically separated from the amplifier and the LED FAULT lights up:
•
for a few seconds after switching-on until the speaker outputs are ready for operation
•
in case of overheating of the amplifier
•
in case of a short-circuit at a speaker output
•
in case of a DC voltage at a speaker output
If the red LED FAULT lights up during operation or if it does not extinguish after switching on, the amplifier
has to be switched off and the cause of the fault has to be removed.
