SmarteLight v1.0 Manual
Revision: 1.1
Page 11 of
17
OmniSite
If primary power is lost while the system is disabled, the system will not run on the backup
battery. This feature is to allow for service of the module without unnecessarily draining the
backup battery.
8.
Input Alarms
Input state change alarms are transmitted when voltage is detected and removed from the “Alarm
Signal” wires. There is 5 second alarm delay before an alarm is transmitted. Although the
SmarteLight has only one alarm channel, several field alarms can be wired in series or parallel to
supply a “general” alarm.
9.
Output Relay
The output relay is controlled by issuing “Output 1” commands from the GuardDog website. This
output can be used to remotely turn on/off equipment, reset an alarm, or silence a horn. The state
of the relay output is preserved between power cycles.
Preliminary
Version
