OmniPrint OM190, Руководство пользователя

Страница: 7 / 20

7
3-6 Loading Paper
Use a paper roll that meets the specifications. Do not use paper rolls that are glued to
the core. Make sure data is not being transmitted to the printer while loading paper.
1. Cut the leading edge of the paper roll straight at a right angle, as shown above.
2. Remove the old paper roll, if any, and press the FEED button until any excess
paper left in the mechanism is out. Do not pull the paper out of the printer
mechanism paper inlet.
3. Mount the paper roll on the paper roll holder by gently bending the plastic tab, on
the right, and insert the roll so that the holes in the core align with the axes of the
paper roll holder. Make sure that the two holders are completely inside the core
so that the paper roll can move freely without much friction, i.e. the core inside
diameter is larger than the paper roll holder’s outside diameter.
4. Hold the both edges of the paper and insert it straight into the paper slot.
5. Press the FEED button until approximately two inches of paper is fed through the
mechanism.
6. Tear the excess paper against the serrated edge and close the cover.
7. Use the following Omniprint part number to reorder paper:
PP-225-135 1 ply paper roll
PP-225-90WC 2 ply paper roll
``````
PUSH
ribbon
change