OmniPrint OM190, Руководство пользователя

Страница: 11 / 20

11
7. Set-up mode
7.1 Set-up By Control Panel Buttons
You can change the printer serial interface, character table, emulation, and print mode
settings by following the procedure below:
1. By turning the power on while pressing the SEL button the printer will print the
current configuration and get into SET-UP mode.
2. The power LED will flash every second to indicate the printer is in SET-UP mode.
3. By pressing the FEED button, in SET-UP mode, you can scroll through the printer
parameters in the order shown in the table below.
4. Pressing the SEL button will cause the setting of a parameter to change in the
sequence shown below.
5. Once the desired setting is selected, it can be saved by pressing the SEL button
while pressing the FEED button.
NOTE: IF NO BUTTONS ARE PRESSED FOR 15 SECONDS, THE SET-UP MODE IS
AUTOMATICALLY TERMINATED WITHOUT CHANGING THE INITIAL PARAMETERS.
PARAMETER (FEED Button) STATUS (SEL Button)
NUMBER OF DATA BITS 8BIT DATA
7BIT DATA
SERIAL PARITY NO PARITY
ODD PARITY
EVEN PARITY
SERIAL BAUD RATE 1200 BAUD
2400 BAUD
4800 BAUD
9600 BAUD
19200 BAUD
38400 BAUD
57600 BAUD
115200 BAUD
STOP BITS 1 STOP BIT
2 STOP BITS
AUTO POWER OFF DISABLE
1 MIN.
5 MIN.
IR PROTOCOL (IR Version only) IrDA 1.1
HP-IR
Raw IR