OmniMount Systems, Inc. • 8201 South 48
th
Street • Phoenix, AZ 85044
1-800-MOUNT-IT • www.omnimount.com
Separate top and bottom projector mounting plates
(
A&B
), by sliding them apart. (Fig. 2) Thread ¼” hex
head set screw (
F
) into side of pipe collar, on top
projector mounting plate (
A
). (Fig. 3)
Note:
If necessary, screw in tilt knob to gain
access to the set screw hole.
Loosely thread top projector mounting plate (
A
) onto
threaded portion of pipe drop.
Note:
For flush ceiling mount, loosely thread top projector mounting plate directly onto threaded portion of
ceiling plate.
Position top projector mounting plate into desired orientation
(horizontal or vertical), and then tighten set screw (
F
). (Fig. 4)
Thread cable bundle through cable management port at top of
pipe assembly, down through the pipe assembly, and then out
through the cable management port on the rear of the projector
mounting plate. (Fig. 5) (Standard ceiling mount only) Be sure to
leave enough cable to reach the mounted projector.
Step 4
Determine required mounting screw size (4, 5 or 6 mm) for projector.
Note:
Consult projectors owners’ manual for screw sizes and mounting holes.
Lay projector on table with mounting surface face up. Place grid section of bottom projector mounting plate onto top
of projector in desired mounting orientation (horizontal or vertical). (Fig. 6) Using a pencil or felt tipped pen, mark
the locations of the projectors threaded inserts onto the grid for reference. (Fig. 7)
Fig. 6
Fig. 7
Fig. 8
Place a large washer (1) over mounting screw, and then insert screw through grid at marked location. (Fig. 8) Lift the
projector mounting plate and place a second large washer (1) onto the end of the screw, followed by a metal spacer
(2). Loosely thread (2-3 turns) screw assembly into the
chosen threaded insert on the bottom of the projector.
(Fig. 9) Repeat this procedure for the remaining threaded
inserts. (Fig. 10)
Note:
A 1” plastic spacer (3) is included for projectors
with uneven mounting surfaces. Trim the plastic spacer to
the required length, and install on appropriate mounting
screw.
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 9
Fig. 10
