OmniMount Systems, Inc. • 8201 South 48
th
Street • Phoenix, AZ 85044
1-800-MOUNT-IT • www.omnimount.com
Step 1
With an electronic stud finder, locate center of ceiling stud in desired mounting location. Unscrew ceiling plate (
E
)
from Projector Mounting top plate (
A
). Use ceiling plate as a template, and mark mounting hole locations. Drill
mounting holes to a depth of 3” using a 3/16” drill bit. Mount ceiling plate to stud with 5/16” lag bolts (
J
).
Step 2
Determine type of installation.
Standard Ceiling Mount
Press plastic cover (
D
) into place over ceiling plate. Attach pipe drop assembly (
C
) to
ceiling plate with three 5/8” hex screws (
H
).
Note:
Orient the cable management port on the pipe drop assembly so that it
faces the projector cable drop.
Extended Ceiling Mount
For installations that require a ceiling drop in excess of 18”, standard 1
½” pipe may be used to extend the standard pipe drop assembly. Pipe
extension should be cut to the required additional length, threaded on
both ends, and then attached to the standard pipe drop assembly with a
pipe coupler (not supplied).
Flush Ceiling Mount
Proceed to step 3.
Note:
Plastic cover is not used for flush mount.
Wall Mount
With the addition of the correct model OmniMount 30.0 (sold separately); the PMD
can be mounted to a wall instead of the ceiling. This is particularly useful for small
conference/classrooms where a ceiling mount is impractical. For details, please
contact OmniMount Technical Support for mounting information.
Step 3
Gently pull the extension tube of the pipe drop assembly down to the required
projector height. Rotate extension tube so that adjustment screw holes are visible
through the support tube. (Fig. 1)
Secure the pipe position by installing 5/8” long hex screws (
I
) into adjustment screw
holes. For a cleaner appearance, insert plastic plugs (
K
) into unused holes on
extension tube.
Fig. 1
