Omnicomm Smart 3.2, Руководство пользователя

Страница: 26 / 38

EN
25
Electronic version
Installation of the device’s components
The terminal must be installed inside the vehicle cabin in close
proximity to the frontal, side or rear window. Due to the fact that
the Terminal has built-in GSM and GLONASS / GPS antennas,it is not
allowed to install the Terminal under metal surfaces and in metal
boxes intended, among other things, for electrical equipment of the
vehicle.
It is possible to connect external GLONASS / GPS antenna which is
recommended to install on a VH rooftop. External GLONASS / GPS
antenna must be installed on a metal surface. Installation on non-
metallic surface is possible with fixation using a glue.
Installation of an external GLONASS / GPS antenna is possible also
inside the VH cabin, but in a place under a clear sky. When installed
inside the vehicle, place the terminal only on horizontal surface and
be sure to check signal reception quality of GLONASS / GPS satellites.
SIM-card installation
Before you insert a SIM-card:
1. Disable the PIN-code requestupon switching on. To do this, insert
the SIM card into any mobile phone and disable the PIN-code
request according to the operation manual of the telephone
2. If you use commands in SMS-messages, enable short message
service
SIM-card Installation procedure:
1. Move the terminal’s protective cover aside
2. Insert the SIM card into the slot until a click