Omnicomm LLS 5, Руководство пользователя

Страница: 27 / 39

EN
26
Electronic version
Sensor preparation
1. Cut the sensor measuring part, considering the following
recommendations:
• the length of the measuring part should be 20 mm less than the
tank depth
• REF channel should be shorter than the sensor measuring part by
min 100 mm. If the difference is below 100 mm, cut REF channel
according to Figure 3.
2. Place the centering wall inside the measuring probe of the sensor
at a depth of 1 cm
REF channel cutting (only when REF channel length is lower than the
measuring part by less than 100 mm):
1. Install the centering retainer wall into REF-channel in close
proximity from the cut-off place
2. Perform a saw cut with the cutoff wheel (diameter max 125 mm)
according to the figure
3. Remove the cutoff of REF-channel rod