OmniCell OmniTT, Инструкция по установке и обслуживанию

Страница: 20 / 41

1-16 Electronics Tray
Standardization Changes
OmniTT/AnesthesiaTT Installation and Service Guide/67-2024 Rev D © 2010 Omnicell, Inc.
Standardization Changes
To standardize the peripherals that Omnicell products use, the Seiko printer and PS/2 keyboards
are being replaced by APS printers and USB keyboards with a numeric pad. The
console is
swapped out in this procedure.
1. Lift and prop-up the lid if it is not already open.
2. Disconnect all console cables.
3. Remove the console.
4. Replace the cable cover bracket with the new, wider one using three screws .
Figure 1-27. Cable cover bracket
5. Place new console into position, then prop it open.
6. Re-connect the cables. Most will go back where the old cables were with a couple of exceptions.
Ž
The contrast cable goes into J33 instead of J32.
Ž
The USB keyboard cable goes to the USB port (vs. the PS/2 connection).
Ž
Move the jumper on JP1 from pins 1-2 to 3-4.