OmniCell OmniRx, Руководство по обслуживанию

Страница: 33 / 52

© 2010 Omnicell, Inc. OmniRx Service Guide/ 67-2023 Rev D
Frames and Wireways 2-7
Manual Override Cable Service
15. Loosen the nut that secures the cable to the back of the frame.
Figure 2-11. Loosen the nut that secures the cable to the frame anchor
16. Pull the cable from the anchor on the back of the frame.
17. Pull the cable out from inside the OmniRx cabinet.
Replacement
1. Feed the cable into the OmniRx cabinet.
2. Replace the screw that secures the manual override cable to the manual override assembly.
3. Place the manual override cable into the frame anchor so that the two screws are on opposite
side of the anchor bracket.
4. Tighten the screws.
5. Feed the front of the manual override cable through the hole on the front of the OmniRx
cabinet.
6. Replace the nut that secures the cable to the frame.
7. Replace the red handle.
8. Replace the two screws that secure the manual override cable to the inside of the front of the
frame.
9. Replace the printer support bracket.
10. Replace the thermal printer paper and the spool.
11. Replace the electronics sled and reattach all cables that had been removed.
12. Close the lid to the electronics tray.
13. Feed the printer paper through the printer.
14. Power up the OmniRx cabinet.