Document number 900-32003 Rev. A
6
Water Resistance Interconnect Cable.
ATTACHING CAMERA to TRACTOR 6-PIN
1.
Make sure camera and Tractor are clean before assembly.
2.
Place camera inside tractor cradle lining up mounting holes.
3.
Bend cradle forks in a 90-degree angle to get access to mounting bolts.
4.
Start 2 screws in front mounting holes by hand.
5.
Start 2 screws in rear mounting holes by hand.
6.
Tighten front and rear screws using Allen wrench. (5/32, long arm)
7.
NOTE: Always tighten front screws first.
8.
Return assembled cradle to its tractoring position.
9.
Locate indexing notch on camera power cable and align with indexing tab on
bulkhead connector.
10.
Align connectors and carefully tighten nut while gently rocking connector to
seat for watertight connection. (Ref. photo below)
DO NOT OVER TIGHTEN.
Bulkhead connector
Camera power cable
Indexing Tab Indexing Notch
