7
SECTION 1. OMNI MIXER & MACRO HOMOGENIZERS
CAUTION: To prevent damage to the drive mechanism, never operate the motor
without a complete chamber assembly or generator probe in position.
CAUTION: Never operate the motor with the generator probe (or sealed chamber
assembly) partially threaded onto the motor. To prevent damage to the motor and
attachments, follow the instructions in Section 2.2 to assure the generator probe (or
sealed chamber assembly, Section 3.4) is fully threaded into the coupling adapter.
NOTE: If you experience excessive vibration, heat, or bearing wear, please contact
technical support at 1-800-776-4431
1.4 GENERAL OPERATING PROCEDURE
The speed of the Omni Mixer or Omni Macro may be regulated to achieve optimum
results when working with different materials. A speed selection knob is located at the
side of the unit, as is a separate “OFF” or “ON” switch. When in the “ON” position
the motor speed can be varied from 0 rpm to maximum speed. Select the optimal
speed for each different combination of sample and accessory for best processing
results.
WARNING: Keep all housings in place and in working order. DO NOT use the
motor in a dangerous environment. DO NOT force the unit to do a job that it was
not designed to do.
