Copyright © 2020 Omix-Ada
®
, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
Complete Soft Top, CJ & YJ with Full Doors
Page
4
/1
0
5
.
Locate Passenger Tailgate Bracket, (2) - #10-24
x 1/2” Phillips Machine Screws, (2) - #10 star lock
washers, (2) - #10 Flat Washers and (2) - #10-24
Nyloc Nuts. In some cases the holes on the
Tailgate Bracket will line up with existing holes. In
this case, use the existing holes as pilots to drill
3/16” holes on the vehicle.
Note:
Carefully check under the drilling area to
be sure you do not drill into any concealed
wiring.
Note:
If you are replacing a hardtop, use the
Tailgate Bracket as a template to drill 3/16” holes.
Position Tailgate Bracket and secure it by using
the hardware listed in this step
Repeat this step for opposite side.
6
.
Lay Bow Assembly on a flat clean surface and
identify the Front and Rear Bow.
Note:
The Front Bow will include foam padding
where as the rear will not.
Assemble the two halves of the Bow Assembly
using the included Connection Tubes with push
buttons.
Note:
It may be helpful to use a flat screwdriver
to push down the buttons while sliding
the
Bow
halves together. Also, it may be helpful for two
pe
ople
to slide both sides of the Bow Assembly
forward simultaneously.
4
.
Locate Passenger Corner Belt Rail, (2)
– 5/16” Torx Screws, (2) – 5/16” Flat
Washers, and (2) – Tapping Plates.
Position Corner Belt Rail onto vehicle
and secure it by using hardware listed
in this step.
Note:
There may be a slight gap
between the Corner and
the
Side Belt
Rail.
This is Normal.
Repeat this step for opposite side.